ITZY OFFICIAL LIGHT RING

ITZY OFFICIAL LIGHT RINGITZY OFFICIAL LIGHT RING Product Components: Outbox Light Ring Cradle QSG Strap You can attach the cradle to the wall and combine the Light Ring to use it as a mood light. Light Mode Normal Mode On > Blink > Flicker > Rainbow Flow > OFF Central Control Mode Capable of functioning by central control at show (Normal mode becomes inoperative when this mode is on) How to Use Replace Batteries Remove the battery cover on the side of the product. Insert the

ITZY OFFICIAL LIGHT RING

• Product Components: Outbox / Light Ring / Cradle / QSG / Strap
• You can attach the cradle to the wall and combine the Light Ring to use it as a mood light.
• Light Mode
  • Normal Mode
    • On -> Blink -> Flicker -> Rainbow Flow -> OFF
  • Central Control Mode
    • Capable of functioning by central control at show (Normal mode becomes inoperative when this mode is on)
• How to Use
  
  • Replace Batteries
    • Remove the battery cover on the side of the product.
    • Insert the three batteries in the correct orientation above the strap connected inside.
  • Installation for Cradle
    • Level the bracket and fix it to the wall with the four screws enclosed. As shown below, assemble the bracket and cradle in sequence.
  • How to Use Cradke
    • Comboine the micro 5 pin terminal located at the top of the cradle and the micro 5 pin hole located on the inner side of the product.
    • The micro 5pin terminal is not for charing but for power supply.
• Attention for using the Cradle
  • About using the Cradle
    • If you insert new batteries into the light ring and combine it with the cradle, it will operate immediately.
    • If the Light Ring has low power batteries and combine wiht the cradle, protective function will be operated automatically for the product. So it takes about ten seconds to operate because it is rebooted after you push the button.